Power Supply - Frigidaire PLCS389ECI Installation Instructions Manual

Power Supply Cord Kit (U.S.A.)
The user is responsible for connecting the power supply
cord to the connection block located behind the back
panel access cover.
This appliance may be connected by means of
permanent "hard wiring" (flexible armored or
nonmetallic shielded copper cable), or by means of a
power supply cord kit. Only a power supply cord kit rated
at 125/250 volts minimum, 40 amperes and marked for
use with ranges shall be used. See chart for cord kit
connection opening size information. Cord must have
either 3 or 4 conductors.
For mobile homes, new installations, recreational
vehicles, or areas where local codes do not permit
grounding through neutral, a 4 conductor power supply
cord kit rated at 125/250 volts minimum, 40 amperes
and marked for use with ranges should be used (see
Figure 5).
Terminals on end of wires must be either closed loop or
open-end spade lugs with upturned ends. Cord must
have strain-relief clamp.
See below for 3 or 4 conductor wire connection.
Range Connection Opening Size Chart
Refer to chart below for proper range connection opening size and power
supply cord kit ampere rating information. See serial plate on appliance for
kilowatt rating data.
Seeserial Plate on the
Appliance for KW Rating
120/240 Volts 120/208 Volts
0- 8.7 kw 0- 7.8 kw
8.8-16.5kw 7.9- 12.5kw
16.6-22.5kw 12.6-18.5kw
Cord Kit
Ampere
Rating
30 Amp
40 Amp
50 Amp
Diameter (inches (cm)) of
Appliance Connection Opening
Direct
Cord Kit Connection
1 1/8(2.9) 7/8(2.2)
1 3/8 (3.5) 1 1/8 (2.9)
1 318 (3.5) 1 318 (3.5)
NOTE: Electric Slideqn Range is shipped from factory
with 1 1/8" (2.9 cm) dia. hole as shown on figure 4. If a
larger hole is required, punch out the knockout.
Risk of fire or electrical shock exists if
an incorrect size range cord kit is used, the
Installation Instructions are not followed, or the
strain retief bracket is discarded.
U.S.A. Style
Figure 1
Do not loosen the nuts which secure
the factory-installed range wiring to terminat block
while connecting range. Electrical faiture or toss of
electrical connection may occur.
Factory Connected Power Supply
Cord (Canada only)
This range is equipped with a factory-connected power
cord (see Figure 2). Cord must be connected to a
grounded 120/240 volt or 120/208 volt range outlet. If
not outlet is available, have one installed by a qualified
electrician.
Canada Style
Figure 2
Electrical Shock Hazard
Electrical ground is required on this appliance.
• Do not connect to the electrical supply untit
appliance is permanentJy grounded.
• Disconnect power to the circuit breaker or fuse
box before making the electrical connection.
This appliance must be connected to a
grounded, metallic, permanent wiring system,
or a grounding connector should be connected
to the grounding terminal or wire lead on the
appliance.
Failure to do any of the above could result in a
fire, personal injury or electrical shock.