Dishwasher Installation - GE GLD4468R10SS Installation Instructions Manual

Built-in dishwasher
Hide thumbs Also See for GLD4468R10SS:
Table of Contents

Advertisement

Available languages

Available languages

Dishwasher Installation
STEP 5: INSTALL POWER CORD
Skip this step if dishwasher
will be permanentlg
connected
to the house electrical
sgstemo
In this step you will need the junction
box cover end the
#20 x !/2" hex heed screw from the screw kit set aside in
Step 1
The power cord and connections must comply with the
Notional Electrical Code, Section 422 end/or local codes and
ordinances, Haximum power cord length is 6 feet Power Cord
Kit WX09X70910. available for purchase from an authorized GE
Appliance Dealer. meets these requirements
Note: Ci_eck That Harness
Leads Are Threaded
Thru
Ground
Smal_ Ha_e in Bracket
/
o Install strain relief injunction box bracket,
• Insert power cord through strain relief and tighten
• Hake sure black, white and green dishwasher wires are
threaded through small hole injunction box bracket
• Connect power cord white (or ribbed} to dishwasher white
wire, black {or smooth) to dishwasher block wire end ground
to dishwasher green wire Use UL-listed wire nuts of
appropriate size,
- Instaltjunction box cover using #t0 hex-head screw Be sure
wires are not pinched under the cover
STEP 6: INSTALL 90 ° ELBOW
• Wrap a 90° elbow with
thread seal tape,
• Thread 90° elbow
onto the water valve
o Do not overtighten
elbow Water valve
bracket could
bend or water valve
fitting could break
Elbow
• Position the end of
the elbow to face the
rear of the dishwashe_
Front of Dishwasher
Weter Valve
Bracket
Thread Seal Tope
Figure K
STEP 7: INSTALL DRAIN HOSE TO
PUMP OUTLET
Skip this step if drain hose has been preinstalled
tn this step gou will need the drain hose and clamp set aside in
Step 1
° Stand dishwasher upright
• Place drain hose clamp over 1-3/16" diameter end of drain
hose Position clamp so screw is on bottom side of hose
Refer to Figure L
I M P0 RTANT - Prevent
drain
hose
damage
end
possible leaks Be careful not to nick or cut the drain hose
• Push the end of the drain hose over the drain pump outlet
being careful not to disturb the check valve Refer to Figure L
• Seat the drain hose end against the hose stops on the
pump outlet
• Position hose clump against the front tip of the drain hose
and tighten clamp
NOTE:Drain hose supplied with dishwasher is approximatelg
78" long, If a longer hose is needed, a 120" long hose 110feetl
mag be purchased from an authorized GEappliance dealer.
The 10' long hose
PumpOutlet
HoseStops
is part number
GPF10L
Figure L
Tip: Avoid unnecessarg service charges. Make a leak free
connection,,
Insert hose against stop on pump Position clamp against front
lip of drain hose with clamp screw on bottom side of hose,
Tighten clamp to at least 15 inch-pounds of torque
Tip: Reduce drain pump noise,
Position drain hose clamp so screw is on the bottom side of the
hose This will prevent noise caused bg the clamp coming in
contact with the tub bottom Refer to Figure L
7

Advertisement

Table of Contents
loading

Table of Contents