Step 16: Connect Water Supply; Step 17: Connect Drain Line - GE GLD4468R10SS Installation Instructions Manual

Dishwasher Installation
STEP 16: CONNECT WATER SUPPLY
Connect water supplg line to 90° elbow
• Slide compression nut. then ferrule over end of water line
• Insert water line into 90 ° elbow
o Slide ferrule against elbow and secure with compression nut
Reroute the water
supplg lines if a
rubbing noise or
interference
occurs
IMPORTANT
-
Checktobe surethat doorspring
and/or door spring cable do not rub or contact the fill hose or
water supplg line ........... Compression
Test bg opening and ,- ...... I Nut ......
closing the door. /' _____J Ferru!e __
Hot Water
_"--9-0"_EIb.0__w.__ Supplg Line
0 0 '
/
' 90 ° Elbow
Figure V
Door Spring
STEP 17: CONNECT DRAIN LINE
The molded end of the drain hose will fit 5/8" through 1"
diameter inlet ports on the air gap, waste tee or disposer.
• Determine size of inlet port
- Cut drain hose connector on the marked line. if required.
to fit the inlet port
Figure W
Cutting Line
/
?
IMPORTANT: Do not cut corrugated
portion of hose
, If a longer drain hose is required and gou did not purchase
drain hose GPF10L odd up to 42" length for a total of 120"
(t0 feet) to the foctorgdnstalled hose Use 5/8" or 7/8" inside
diameter hose end a coupler to connect
the two hose ends
Secure the (_
connection
with hose
clamps Coupler
Figure ×
Hose Clamp
Hose Clamp
NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10 FEET
FOR PROPER DRAIN OPERATION
, Connect drain line to air gap. waste tee or disposer
using the previousig determined method Secure hose
with a screwqgpe clamp
Method 1 - Air gap with waste tee or disposer
R --_ FI............
Waste Tee Installation
Disposer installation
Figure V
Method 2 - "High drain loop" with waste tee or disposer
With this method gou will need the drain hose hanger set aside
in Step !
Fasten drain hose to underside of countertop with the provided
hanger.
Drain Hose Hanger
-- :--:_:::: '_ :
T
WasteTeeInstallation
Figure Z
DisposerInstallation
I M PORTANT
- When connecting drain line to
disposer, check to be sure that drain plug has been removed
DISHWASHER WILL NOTDRAIN_FPLUGISLEFTIN PLACE
4 Remove
Drain
Plug
Tip: Avoid unnecessarg service call charges for a no drain
complaint.
Make sure excess drain hose has been pulled through
the cabinet opening This wit! prevent excess hose in the
dishwasher cavitg from becoming kinked or crushed bg the
dishwasher.
II