GE ZIC360N RH Design & Installation Manual page 14

Installation Instructions
[STEP INSTALL FRAMED PANELS
Right hand models shown. Use the same instructions for
left hand models.
IF YOU ARE INSTALLING OVERLAY PANELS, GO
TO STEP 9A.
- UseFrontHoles
to SecureTrim
"_-_ Jse RearHoles
to SecureHandle
Handle _- DoorTrim
Trim
Refrigerator
Door
Standardsuppliedhandleshown
in 1/4" panelposition,
Install door and drawer panels:
• Open door to 90 °. Remove the 4 Phillips head screws
from the door handle.
• Remove handle. Retain all screws.
• Remove 4 screws holding trim, lift off trim. Retain
SCFeWS.
• Slide framed panel into the door trim.
• There are two sets of holes in the handle side trim.
Replace handle side trim by installing the original
screws in the FRONT screw holes.
• Secure the handle to the door using the REAR screw
holes.
• Follow the same procedures to install the drawer panel.
Custom handles
If you are using custom handles, the handle must be
properly secured to the panel before sliding the panel
into the trim.
• The cabinet manufacturer will supply the custom
handle and hardware.
• Secure the door/drawer trim using both the FRONT
and REAR screw holes. Discard supplied handle.
14