Installation
Instructions
I STEP 101CONNECT
WATER SUPPLY
Check to be sure that refrigerator
power cord is not
plugged into the wall outlet.
\
House
Refrigerator
_,_ater
Supply
\
Water
Supp_
• Locate and bring copper
tubing to the front of the
cabinet.
• Turn the water on to flush debris from line. Run
about a quart of water through
tubing into a bucket,
then shut-off water.
• Slip a 1/4" nut and ferrule
(provided)
over both
ends of the copper tubing. Insert tube into the
union fitting on the unit and tighten nut to union.
• Turn on the water to check for leaks.
Note: Make sure excess tubing length does not
interfere
with drawer closing or toekick installation.
[STEP 111 CONNECT
POWER
• Connect
refrigerator
power cord plug to a properly
grounded
receptacle,
accessible through
the top
left side of the grille opening.
Electrical
Master Eight
Outlet
Switch
I
Raiae
Grille_1
Panel _ '
• Check to make sure power to refrigerator
is on by
opening
refrigerator
door to see if interior
lights
are on.
• The temperature
controls are preset at 37°F for the
fresh food section and 0°F for the freezer.
• Allow 24 hours to stabilize before making
adjustments.
[STEP 12] START ICEMAKER
• Flip the switch to I (ON). The icemaker will begin
operation
automatically.
• Be sure nothing
interferes
with the sweep of the
feeler arm.
• Discard the first full bucket of ice cubes.
• To turn the icemaker off, set the switch to O (OFF).
ISTEP 13 ]INSTALL TOEKICK
•
Locate the supplied
toekick
(shipped taped
to
the
side
of the
refrigerator).
Install
with
2 screws
provided,
adjust
to desired
height
and
tighten
screws.
•
A
custom
toekick
can
be installed
to match
or
complement
the
surrounding
cabinetry.
Use
the
supplied
toekick
as a template
to cut
out
the
notch
and
vent
holes.
SuppliedToekick
1/4" or ThickerToekick
Important:
The
vented
toekick
must
remain
unob-
structed
for
proper
air
circulation
and
refrigerator
operation.
16