Installation
Instructions
[STEP 71 ADJUST
DOOR SWING
NOTE: This refrigerator
has a 2-position door stop.
When space does not allow the door to swing open
fully to
130°,
you may change
the door swing to a 90 °
opening.
Skip this step if door opening is satisfactory
for your installation
situation.
* Lift the grille panel to access the wire cover trim.
. Remove screws on both sides of the wire cover trim
and lift off.
. Use pliers to unscrew door stop and reinstall into
the 90 ° position.
I
I
_
zJ
Remove
WireCover
TrimScrews
PinLocationFor
90°
PinLocation
as Shipped
130° DoorSwing
* Reinstall the wire cover trim.
[STEP 8 1 INSTALL GRILLE PANEL
, Raise the grill panel to stop position.
Looser_n f
Side m
Trim •
Screw
I
Raise ÷ 4/
Grille/[
I
P_
_
jz
Adjust N utBelow
Spring toAccommodate
Panel Weight
Loosen
Side
Trim
Screw
* Loose screws on side trim behind
frame. Remove
bottom
trim.
. Slide panel over the metal baker panel and into the
trim.
* If necessary, tap with a wood block until panel slips
under the top trim piece.
. Reassemble
bottom trim. Tighten screws.
. Adjust the hinge spring to accommodate
the panel
weight, if necessary.
13