Step 10 Adjust Door Swing; Step 11. Remove Door Trim - GE Side by Side Refrigerators Installation Instructions Manual

STEP 10 ADJUST DOOR SWING

NOTE: This refrigerator has a 3-position door stop.
When space does not allow the door to swing open
fully to 115°, you may change the door swing to a
90° opening. A 130° door swing option is available
for standard installation only. Skip this step if door
opening is satisfactory for your installation situation.
• Open the door to view the bottom hinge.
Note the door stop pin locations. The pin is factory
installed in the 130° position.
• Close the door. From below, use pliers to unscrew
the door stop and reinstall into the 90° position.
STEP 11 REMOVE DOOR TRIM - FLUSH INSTALLATION ONLY
Use the supplied Torx wrench or T10 Torx head driver to
remove all exposed trim screws securing aluminum trim
to refrigerator doors. Save all trim and screws as they
will be replaced in a later step.
1. Remove screws from door hinge side of both left and
right doors. Once screws are removed, remove trim
from hinge side of each door.
Hinge side
trim
Installation Instructions
Handle
side trim
19
2. Remove 4 trim screws on vertical handle side on each
door to release handle cover trim. Remove the handle
cover trim from the handle side of each door to expose
handle visor trim underneath.
3 Remove 4 additional trim screws from handle visor
trim on each door. Once screws have been removed,
remove handle visor trim from each door.
Handle
visor trim
Hinge side
trim