Preventive Maintenance; Wrench - BLADEZ BF 635 HRP Owner's Manual

Hide thumbs

Table Of Contents

Table of Contents

The running belt can shift to one side or simply 'skid over'

when running.

To center the belt using the 6mm Allen

wrench, run the machine at 3mph for a few minutes to

determine which side the belt is drifting towards; left or

right.

If the belt is drifting left

i) Turn the treadmill off and unplug from the machine

ii) Tighten the left bolt a ¼ turn (clockwise)

iii) Loosen the right bolt a ¼ turn (counterclockwise)

iii) Run the belt at 3 mph again for a few minutes

If the belt continues to drift to the left, repeat steps

If the belt is drifting right

i) Turn the treadmill off and unplug from the machine

ii) Tighten the right bolt a ¼ turn (clockwise)

iii) Loosen the left bolt a ¼ turn (counterclockwise)

iii) Run the belt at 3 mph again for a few minutes

If the belt continues to drift to the right, repeat steps

Once the running belt has been adjusted closer to the

center, the treadmill can be powered on again.

It is recommended that the deck be lubricated every

6~12 months according to the frequency of usage.

WARNING!

Do not use cleaner under the running belt.

i) Use 6mm Allen wrench to loosen the bolts in the

end caps. Remove excessive accumulations of dust,

dirt, and other substances from running deck. ONLY

use a clean soft cloth.

ii) Gently pull up the side of the running belt, and

dispense a think layer of the lubricant on deck, and

spread evenly. DO NOT over lubricate

iii) Center the belt (top of this page), and tighten the

end caps.

Check belt condition and adjust if necessary referring

to the steps above.

BladeZ Corporation • 20155 Ellipse • Foothill Ranch • CA • 92610

www.ebladez.com

SECTION 5