Getting Started - BLADEZ BF 635 HRP Owner's Manual

MOVING THE TREADMILL
The treadmill has wheels located at the front as part of the elevation assembly. Elevate
the treadmill up to 10% or greater then un plug. Next lift the rear of the treadmill and
push the treadmill using the front wheels.
SAFETY KEY & CLIP
Your Bladez treadmill is equipped with a safety key that will disable the treadmill if it is
not in place. You should attach the clip end to your clothing. The magnet end goes into
the recess of the console. If at any time you need to stop the treadmill quickly simply
pull the safety key off the console. This will cut all power to the treadmill and it will
come to a complete stop. To resume your workout, place the safety key back in place.
You will then need to program your workout again.
BEFORE STARTING
Straddle the running belt and stand on the plastic side rails. Insert the safety key and
attach the rope to your clothing. Do not stand on the walking belt while starting or
stopping the treadmill.
KEY FUNCTIONS
START – This key is used to begin any treadmill program or quick start.
MODE – This key is used to enter into the program mode. It is also used to
change the values on the display readout such as changing from
ELEVATION to PULSE.
STOP – This key is used to stop the treadmill at any time. Press the STOP
button and hold for 3 seconds and the treadmill will reset itself.
This key is used to change values during programming
It is also used to adjust the speed on the treadmill.
This key is used to adjust the elevation on the treadmill.
BladeZ Corporation • 20155 Ellipse • Foothill Ranch • CA • 92610
www.ebladez.com
SECTION 3

GETTING STARTED

9
• Phone 949-206-0330 • Fax 949-206-0350