Preventive Maintenance - BLADEZ POWERMILL BF-6422 Owner's Manual

PREVENTIVE MAINTENANCE

If the running belt has shifted to left or
right off the center or simply skid when
running, please refer to the following
1. Turn the power off.
2. Use a 6mm wrench to tighten the
rear roller bolt on the side of the
treadmill toward which the belt is
moving as shown.
3. Tighten about
(clockwise).
Note: If the belt does not move
back to the center of the treadmill,
make another adjustment to the
same bolt until the running belt
moves closer to the center.
Once the running belt has been
adjusted closer to the center, the
treadmill can be powered on again.
It is recommended that the deck be
lubricated every 6~12 months according to
the frequency of usage.
Use 6mm Allen wrench to loosen the bolts
in the end caps. Remove excessive
accumulations of dust, dirt, and other
substances from running deck. Use a clean
soft cloth.
Warning! Do not use cleaner under the
running belt.
Pull up running belt, dispense lubricant on
deck, and spread evenly.
After lubricating deck, center the belt,and
tighten the end caps. Check belt condition
and adjust if necessary referring to the
steps above.
SECTION 5
1/4 of turn
16
Rear Roller Bolt
6 mm wrench
0.5~4.0 Mile lubricate every 1 year
4.0~7.0 Mile lubricate every 6 months
7.0~10.0 Mile lubricate every 3 months