Kenmore 630.1399 Installation Manual page 9

For a large port, use the drain hose as it is.
Far a small port, insert the rubber drain hose adaptor into
the drain hose end as shown below.
1. Obtain the Rubber Drain Hose Adaptor screw clamp
from the Dishwasher Installation Kit (do not substitute).
2. Insert the dishwasher drain hose into the end of the drain
hose. Be sure to fully insert the drain hose.
3. Use the clamp provided to attach the Rubber Drain
Hose Adaptor to the house plumbing. Tighten until hose
can no longer rotate.
Drain Hose
Rubber drain
hose adaptor
Before installing the supplied countertap mounting brackets,
decide which method of securing the dishwasher into its
enclosure will be used. Once the mounting brackets are
installed an the dishwasher, removing them is difficult and
will damage the mounting brackets and the dishwasher.
The dishwasher can be secured into its enclosure in two ways:
1. Top Mount is used for countertops made of wood
or other materials that can easily drilled. Orient the
mounting brackets as shown below and position the
the mounting brackets over the slots on the dishwasher's
front corners. Push the mounting brackets down firmly to
insert the tabs into the slots.
Top Mount
Do not use the dishwasher until it is completely installed.
When opening the door an an uninstalled dishwasher,
carefully open the door while supporting the rear of the
unit. Failure to fallow this warning can result in serious
iniury.
°
9
Side Mount is used far cauntertaps made of marble,
granite, or other very hard materials that cannot be
easily drilled. Bend the mounting brackets along the
small holes and in the same direction as the two small
tabs. Orient the mounting brackets as shown below, and
position the two small tabs on the mounting brackets
over the two slats on the dishwasher's front corners.
Push the mounting brackets down firmly to insert the
tabs into the slots.
Side Mounl