Advertisement
Available languages
Available languages
3. Insert the bare copper
or green wire(ground)
to the "G"
ground
connection
of the terminal
block and securely
tighten
the terminal
block screw.
4. insert the white (neutral) wire to the "N" connection
of
the terminal
block and securely
tighten the terminal
block screw.
5. Insert the black(hot)
wire
to the "L" connection
of the
terminal
block
and
securely
tighten
the terminal
block
screw.
6. Check aJJ eJectrica! connections to make sure they are
secure and then attach the junction box cover with the 4
screws.
Hot Water Supply
The hot water
heater should be set to deliver
approximately
120 ° F (49 ° C) water
to the dishwasher.
Water
that is too hot can cause some detergents
to lose
effectiveness.
Lower water
temperatures
wJJl increase
run
times. The hot water
supply
pressure must be between
15 - 145 psi (1 - 10 bar).
IMPORTANT
NOTES:
•
if using a solder joint instead
of a compression
fitting,
be sure to make a!l solder connections
before
connecting
the water
supply
line to the dishwasher.
•
Make
sure there are no sharp bends or kinks in the
water
line that might restrict water
flow.
•
Always
use the appropriate
seal when making
plumbing
connections.
•
Before connecting
the water
supply
line to the
dishwasher,
flush the incoming
water
line for
approximately
5 minutes to clear any foreign
material.
•
Turn on the water
supply and check for leaks after
connections are made.
METHOD
A & B
As a final step, connect the dishwasher
power supply
plug
(connected
to the junction box at the other end) in the slot
at the bottom
of the dishwasher
as shown below.
Connecting the Hot Water SuppJy
There are two plastic corrugated
hoses that exit the back
of the dishwasher.
The larger
hose, with the brass fitting
on the end, is the water
supply
hose to the dishwasher
(the
other hose is the dishwasher
drain hose). You will need a
3" x 13/4" (7.6 x 4.5cm) opening
through
the cabinet
to
pass the dishwasher
water
supply line through
toward
the
shut off valve.
Dishwasher
power
supply
plug
Temperatures
required
for soldering
and sweating
will
damage
the dishwasher.
Jf plumbing
lines are to be
soldered
or sweated,
keep the heat
source at least 6 inches (152.4
ram) away from
the dishwasher.
Advertisement
