Avoidscalding Or Electrical Shock H Azard - Kenmore 630.1399 Installation Manual

AvoidScalding or Electrical Shock H azard[
Make
sure the water supply and electrical supply are
shut off before installation or service.
After locating the proper place for your new dishwasher,
you will need to make any required openings to allow far
passage of the water, drain and electrical line. In order
to avoid interference with the dishwasher when sliding it
into the cabinet, place your openings within the dimensions
shown below.
NOTE: This dishwasher is designed to be enclosed on
the top and both sides by standard residential kitchen
cabinetry.
Select a location as dose to the sink as passible far easy
access to water supply and drain lines.
Far proper dishwasher operation and appearance, ensure
that the enclosure is square and has the dimensions shown
below.
i
4-1/2'!
_(!!4rnrn) f
! 2-1/2"
[(64mm)
REQUIRED OPENINGS:
41/4 '' X 2" (1 0.8 X 5.2cm) - To pass the included electrical
supply [unction box through to
an adjacent cabinet
4"x2"(10x5cm)- To pass the included water
supply line toward the water
supply
11/4_
(3.2cm) diameter - To pass the dishwasher drain hose
toward the drain connection
If the dishwasher is to be installed in a corner, make sure
that there is adequate clearance to open the door.
Check,¸
between / Countertop
dishwasher door
and wa
Avoid Electrical Shock/Fire Hazard
Do not allow the electrical and water supply lines to
touch.
NOTE: if the incoming electric supply, water supply and
drain connections are all in the same cabinet, the one
41/4" x 2" (1 0.8 x 5.2cm) hole will be large enough far all
three to pass through.
Before sliding the dishwasher into the cabinet, remove the
hose clip at the back of the dishwasher as shown below
and discard.
................... i ........................... i............
5