Download Print this page

Kenmore 630.1399 Installation Manual page 8

Hide thumbs Also See for 630.1399:

Advertisement

Available languages

Available languages

To
connect the hot water supply:
1. Assemble
the water supply adaptor
fitting from the
parts bag onto the dishwasher
water
supply
hose. This
connection
does nat require
Teflon brand
tape.
2. Pass the dishwasher
water
supply
line with attached
adaptor
through the opening
toward
the water
shut off
valve. Take care not to allow
the hose to kink or twist
behind the dishwasher.
3. Connect the dishwasher
water
supply
line with adaptor
to the water
shut off valve. You will need to use an
approved
dishwasher
water
supply line with the correct
fittings
for this connection.
Always
use the appropriate
seal when making
plumbing
connections.
NOTE: The end of the dishwasher
water
inlet hose is
heavy
and will need to be supported.
It is best to lay
the end an the cabinet
floor.
4. After
all connections are made, turn on the hot water
and check far leaks.
IMPORTANT
NOTES:
If local ordinance
require
an air gap, install it according
to the manufacturer's
instructions.
If the dishwasher
drain
hose is to be connected
to a
disposer
dishwasher
drain
connection,
remove the plug
from the disposer's
dishwasher
drain connection.
The dishwasher
drain hose must have one place along its
length that is securely attached
20 inches (50.8cm)
above
the cabinet
floor.
The drain hose length can be extended
if necessary. The
maximum
length
of the drain
hose, including the hose
leading
to the air gap, is 150 inches (381 cm).
The dishwasher
drain hose may be connected
to the
household
or field drain plumbing
in one of four ways. You
will need a 11/,,
(3.2 cm) diameter
hole in order
to pass
_4
the drain hose through the cabinet.
Avoid Scald Hazard
Do not perform
any work on a charged
hot water
line.
Serious injury could result. Only
qualified
plumbers
should
perform
plumbing
work. Do not attempt
any work on
the dishwasher
hot water
supply
plumbing
until you are
certain
the hot water
supply
is shut off.
Non-Metallic
Tie
\
_ MIN.
2o"
151cm
...... J
....
Directly to the undersink
Directly to a disposer
dishwasher drain connection,
dishwasher drain connection.
To the undersink
dishwasher
drain
connection
through
an
air gap.
To a disposer dishwasher
drain connection through an
air gap.
8

Advertisement

loading