Checking The Drive Bay Setup - Supero SUPERSERVER 6016T-MR User Manual

S S
UPER ERVER 6016T-MR User's Manual
2-6

Checking the Drive Bay Setup

Checking the Drives
1. For servicing the SATA and DVD-ROM drives, you will need to remove the
top chassis cover. The SATA disk drive is located at the front of the chassis'
interior.
2. Refer to Chapter 6 if you need to reinstall a DVD-ROM drive to the system.
3. Depending upon your system's confi guration, your system may have a SATA
hard drive already installed. If you need to install a SATA hard drive, please
refer to the appropriate section in Chapter 6.
Checking the Airfl ow
1. Airfl ow is provided by sets of 4-cm counter-rotating fans. The system compo-
nent layout was carefully designed to promote suffi cient airfl ow through the
small 1U rackmount space.
2. Also note that all power and data cables have been routed in such a way that
they do not block the airfl ow generated by the fan.
Providing Power
1. The last thing you must do is to provide input power to the system. Plug the
power cord from the power supply unit into a high-quality power strip that of-
fers protection from electrical noise and power surges. It is recommended that
you use an uninterruptible power supply (UPS).
2. Finish by pushing the power button on the control panel to power up the
system.
2-10