Table of Contents
Advertisement
RAID Configuration
Enable RAID Function
For any RAID controller, the general procedure to enable RAID function are shown
below:
Note: If you are not installing O/S into the RAID
disks, you may skip Step 3 & Step 4.
Step 1: Enable RAID ROM
The system BIOS may disable all RAID function by default. To enable any RAID
controller you must enable its RAID Boot ROM. Enter the BIOS CMOS Setup and
jump to Integrated Peripherals Page.
Select the controller's Boot ROM and set it to Enabled. Press "F10" to Save & Exit.
Page 5-4
Advertisement
Table of Contents
Need help?
Do you have a question about the nForce4 4X and is the answer not in the manual?
Questions and answers