IKEA IH5303SS0 Installation Instructions And Use & Care Manual page 8

Vent Cover Bracket Installation
Installations using telescoping upper and lower vent cover
assembly
1. Position vent cover bracket on wall about 1/8"(3 mm) away
from the ceiling.
2. Mark the hole locations.
I A
i .........................
i .......................... C
A. Vent cover bracket
B. Mounting hole locations
C. Centerline on waft
3. Drill 3/8"(9.5 mm) holes for wall anchors and insert anchors
flush with the wall.
Vent Cover Bracket Assembly and Installation
4. Assemble the 3 pieces of the vent cover bracket using
four 4 x 8 mm screws provided. The assembled bracket
should be sized to fit inside the upper vent cover.
5,
A. Vent cover bracket assembly
B. Upper vent cover
C. 4 x 8 mm screws
D. Adjustable width
Install vent cover bracket to wall about 1/8"(3 mm) away from
the ceiling with drywall anchors and 6 x 70 mm screws
supplied.
I
i ............... A
i B
Non-vented (recirculating) Installation
1,
Assemble the 3 parts of the deflector with two 3.5 x 9.5 mm
screws provided. The assembled deflector should be sized to
fit the width of the vent cover bracket installed earlier.
C
2=
A. Vent cover bracket width
B. Deflector
C. 3.5 x 9.5 mm screws
Connect the deflector to the vent cover bracket using
four 3.5 x 9.5 mm screws provided.
B
I I
I I
A. Vent cover bracket
B. 3.5 x 9.5 mm screws
3. Measure length of 6" (15.2 cm) vent needed to connect the
transition to the deflector.
NOTE: Vent should fit up inside deflector a minimum of
1" (2.5 cm) minimum.
4. Install vent between the transition and the deflector.
5. Seal all connections with clamps.
A. Vent cover bracket
B. Centerline on wall
8