Light Bulb Replacement; Headlight; Taillight; Fuse Replacement - Cushman SHUTTLE 2+2 G Owner's Manual

Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.

LIGHT BULB REPLACEMENT

To decrease the risk of premature bulb failure, do not allow your fingers to contact new bulbs. Use clean, dry

Headlight

To prevent the bulb from accidentally disconnecting and possibly melting or igniting plastic components, the
locking ring MUST be installed again after installation of replacement bulb.
Rotate the bulb socket a quarter turn to the left to unlock.
Remove the bulb and socket. Install new bulb and rotate
the socket a quarter turn to the right to secure.
Replacement bulbs are available from a local Distribu-
tor, an authorized Branch or the Service Parts Depart-
ment.

Taillight

Remove two Phillips head screws that secure the lens.
Pull the lens from the housing to access the taillight bulb.
Remove the light bulb and install a new bulb. Make sure the bulb con-
tacts the socket correctly.
Replace the lens and install the Phillips head screws.
Replacement bulbs are available from a local Distributor, an authorized
Branch or the Service Parts Department.

FUSE REPLACEMENT

The fuse block is found below the driver seat. Lift the seat bottom to access the fuses.
Remove the old fuse and replace with a new fuse of the same type and size.
Fuses are available from a local Distributor, an authorized Branch or the Service Parts Department.
paper or paper towels to touch the glass part of the bulb.
Taillight Bulb
Owner's Guide
MAINTENANCE
Inside of Cowl
Headlight Housing
Screw
Headlight Bulb
Rear Fender
Taillight Lens
B
31