The Functions Panel - Husqvarna Viking Platinum 995E User Manual

The Functions Panel

Stitch length
When you select a stitch, your Platinum 775
automatically sets the best stitch length. The
set length is visible on the display above the
stitch length button. You can change the
stitch length by pressing either the (+) or (-)
button. Some stitches have a limited stitch
length. Minimum and maximum settings are
indicated with a "beep" signal.
Stitch width
The stitch width is set in the same way as
the stitch length. The set width is visible on
the display above the stitch width button.
The width can be adjusted between 0 and 6
mm. If straight stitch is selected, the width
button is used to adjust the needle position.
Some stitches have a limited stitch width.
Minimum and maximum settings are indi-
cated with a "beep" signal.
Twin needle
When pressing this button, a pop-up mes-
sage appears on the display, prompting
you to set the twin needle width. Select the
width by touching the selection buttons.
A twin needle icon is shown in the upper
left corner of the display. Touch the button
again to see the current twin needle setting.
Functions and InfoDisplay on your Platinum 775
The stitch width is automatically adjusted to
t the set twin needle width. The stitch set-
tings remain until the twin needle function
is turned off.
The twin needle function is active until
you cancel it, even if your Platinum 775 is
turned off. Touch the twin needle button
and set the value to "0" to turn off the
function.
Mirror Side to Side
Touch this button to mirror the selected
stitch side to side. If this button is pressed
when straight stitch with left needle posi-
tion is selected, the needle position is
changed from left to right. If touched in
rep, the whole stitch combination is mir-
rored (see page 31).
If you try to mirror a stitch that cannot be
mirrored, Platinum 775 beeps.
Mirror End to End
Touch this button to mirror the selected
stitch end to end. If touched in rep, the
whole stitch combination is mirrored (see
page 31). If a stop is programmed at the
end of a combination, and the combina-
tion is mirrored end to end, the stop will be
placed at the beginning instead.
If you try to mirror a stitch that cannot be
mirrored, Platinum 775 beeps.
19