Elastic Foot - Husqvarna Viking Huskylock 901 Operating Manual

7-3. Elastic Foot (1650002-450)

Elastic foot is used with both 3-thread 2-needle,
and 4-thread 2-needle overlock sewing. This foot
guides your elastic and stretches the elastic with
the tension control screw on the foot while sewing.
(1) Replace the regular foot with the elastic foot
(see p. 5).
(2) Set the stitch length to 4 and the stitch width to
4.5 for 4-thread overlock sewing.
• For 3-thread overlock sewing, set the stitch width
to 3.0.
(3) Raise the elastic foot, loosen the tension
control screw on the elastic foot and insert the
elastic until it extends behind the foot.
(4) Lower the elastic foot and sew on the elastic for
a few stitches to make sure the elastic is being
properly sewn.
(5) Place the fabric under the foot and sew
together with the elastic.
(6) Check the stitch formation and if necessary,
adjust the tension control by tightening or
loosening the screw on the foot.
Tension Control Screw
Elastic
Fabric
–29–
Tension Control
Screw