Husqvarna Viking Huskylock 901 Operating Manual page 11

➉
➈
➉
11
⑨
Fig. E
➆
➆
➇
As the upper cutter is sharp, handle
❈
the moving part with care.
Fig. B
11
Fig. C
Fig. D
C
B
A
(2) Lower looper threading (B)
Open the front cover and the side cover.
Take the thread drawn from the spool and pass it
through guide of the thread stand and then, in
order, through guide
(Fig. A).
Pass the thread through guides
Bring the lower looper to the far left position by
turning the handwheel toward you, and pass the
thread through lower looper thread guide
Pass thread through lower looper slit
to forward (Fig. B).
Move the lower looper slightly to the right by
turning the handwheel toward you.
Then thread the eye of lower looper 11 using
tweezers.
Cut the thread leaving about 10cm (4") of thread
tail (Fig. C).
(3) Right needle threading (C)
• For easy threading, disengage the moveable
cutter by turning it downward. Push the upper
cutter holder screw
left hand and turn the right end of the holder
with your right fingers in the direction of arrow
(Fig. E).
• Take the thread drawn from spool, and pass it
through thread guides
eye of right needle
tweezers.
Cut the thread leaving about 10cm (4") of thread
tail (Fig. E).
(4) Left needle threading (D)
• Take the thread drawn from spool, and pass it
through thread guides
the eye of left needle
A, E).
• Return the moveable cutter to the cutting position.
Warning:
Make sure the cutter is returned to the cutting
position before start sewing. Otherwise, it may
cause some serious damage to your machine.
–6–
and thread tension dial
and
from back
with the forefinger of your
A
~ . Then thread the
from front to back using
- , - , and thread
from front to back (Fig.
.
.
C
B