Changing Thread - Husqvarna Viking Huskylock 901 Operating Manual

2-2. Changing Threads
The following is an easy way to change threads;
(1) Cut the thread in use near the spool (behind
the telescopic thread stand). Place the new
thread on the spindle and tie it to the end of the
original thread.
(2) Raise the presser foot.
(3) Set tensions to 0 so that the thread knot can
pass through the guides smoothly. Draw out
the looper thread until the thread knot comes
to about 10 cm (4") past the presser foot.
(4) When changing the needle thread, cut off the
thread knot before it reaches the eye of the
needle. This prevents bending or damaging the
needle.
To make threading easier, use tweezers.
Tying threads
Needle eye
–7–
Cutting thread