Preparations; Unpacking; Connect The Power Cord And Foot Control - Husqvarna Viking Designer Jade 35 User Manual

2 Preparations

Unpacking

1. Place the box on a sturdy, flat surface. Lift the machine
out of the box and remove all packing material and the
plastic bag.
2. To remove the storage box, turn the locking device
located at the rear side of the box to the left and push the
box forward.
3. Wipe the machine, particularly around the needle and
needle plate to remove any oil before sewing.
Note: Your HUSQVARNA VIKING® DESIGNER JADE™
35 machine is adjusted to provide the best stitch result at normal room
temperature. Extreme hot and cold temperatures can affect the sewing
result.
Note: Some fabrics have excess dye which can cause discoloration on
other fabrics or on your sewing machine. This discoloration may be very
difficult or impossible to remove.
Fleece and denim fabric, especially red and blue, often contain excess dye.
If you suspect that your fabric/ready-to-wear garment contains a lot of
excess dye, always pre-wash it before sewing/embroidering to prevent
discoloration of your machine.
Connect the Power Cord and Foot
Control
Among the accessories you will find the power cord and the
foot control.
Note: Consult a qualified electrician if you are in doubt about how to
connect the machine to the power source. Unplug the power cord when
the machine is not in use.
For this sewing machine, foot control model C-9002
manufactured by CHIEN HUNG TAIWAN Ltd must be
used.
1. Connect the foot control cord to the front socket on the
bottom right side of the machine (A).
2. Connect the power cord to the rear socket on the bottom
right side of the machine (B). Plug the cord into the wall
socket.
3. Press the ON/OFF switch to ON to turn on power and
light (C).
For the USA and Canada
This sewing machine has a polarized plug (one blade wider
than the other). To reduce the risk of electric shock, this
plug is intended to fit in a polarized outlet only one way. If
the plug does not fit fully in the outlet, reverse the plug. If
it still does not fit, contact a qualified electrician to install
the proper outlet. Do not modify the plug in any way.
2 Preparations 13