Kenmore 27" Installation Instructions Manual page 12

_4, Connect neutral wire
Place hooked end of neutral wire (white or cente) (C) of direct
wire cable under center terminal block screw (B). Squeeze
hooked end together. Tighten screw.
Connect neutral ground wire
and neutral wire
Connect neutral ground wire (E) and neutral wire (white or
center wire) (C) of power supply cord or cable under center
terminal block screw (B). Tighten screw.
Place hooked ends of remaining direct wire cable wires
under outer terminal block screws (hooks facing right).
Squeeze hooked ends together and tighten screws. Finally,
reinsert tab of terminal block cover into slot of dryer rear
panel. Secure cover with hold-down screw. Now, go to
Venting Requirements.
Optionam 3owire Connection
You must verify with a qualified electrician that this
grounding method is acceptable before connecting.
Place hooked ends of remaining wires under outer terminal
block screws (hooks facing right). Tighten screws.
Remove center terminal block screw (B). Remove neutral
ground wire (E) from external ground conductor screw (A).
Connect a separate copper ground wire (G) from the external
ground conductor screw (A) to an adequate ground. Finally,
reinsert tab of terminal block cover into slot of dryer rear
panel. Secure cover with hold-down screw. Now, go to
Venting Requirements.
12