Opticon PHL-7100 User Manual page 79

Example :
To set a prefix 'Test' for UPC-A, lookup in Opticon's Universal Menu Book (UMB) the serial
command's of :
- prefix UPC-A : see UMB paragraph 4.2.1, serial command = N1
- Direct input 'T' : see UMB paragraph 4.3.4, serial command = 0T
- Direct input 'e' : see UMB paragraph 4.3.5, serial command = $E
- Direct input 's' : see UMB paragraph 4.3.5, serial command = $S
- Direct input 't' : see UMB paragraph 4.3.5, serial command = $T
Input these 5 commands into the Command line field by using the keyboard Input panel.
If the Send button is pressed, the serial command sequence is send to the bar code reader.
To save the settings in the bar code reader, add the commands Z2 after the last command
sequence.
See picture below :
Figure 3-19 Example of command line usage.
3-16
OPTICON
User's manual
PHL-7000 series