Opticon PHL-7100 User Manual page 66

Keybd Message
Read mode
Read time
None Disable beep after scanning bar code.
One Time Beep one time after scanning bar code
(default).
Two Times Beep two times after scanning bar code.
Select the bar code data transfer method
Disable Data from bar code reader is ignored.
Type Data from bar code reader is send as
Writing keyboard data to the application which
currently has the focus (default).
Select the bar code reading mode.
Single When a bar code has been decoded, the
read reader will be turned OFF. The reader
must be triggered again to read another
bar code (default).
Multiple When a bar code has been decoded, the
read reader will stay ON for the time as set by
'Read time' options. The same bar code
can only be decoded again after the label
has not been detected for a number of
scans.
The length of the period that the reader is ON after the
trigger switch is pressed, or (in multiple read mode),
after a label has been read.
0 sec Reader will stay on as long as the trigger
switch is being pressed.
1 sec 1 second
2 sec 2 seconds (default)
3 sec 3 seconds
4 sec 4 seconds
5 sec 5 seconds
6 sec 6 seconds
7 sec 7 seconds
8 sec 8 seconds
3-3
OPTICON
User's manual
PHL-7000 series