Table of Contents
Advertisement
Digital Video Network Surveillance System
5.14 Network Parameters
If you want to use network to access DVR, you must setup network parameters.
Note: If any network parameter is modified, you must save and reboot DVR
to make it become effective.
In main menu, move "Active Frame" to "Network" icon and press [ENTER], you
can enter "Network" menu as follows: Shown as Fig.5.28 below
"Network" menu description:
IP address: This IP address must not be conflict with other IP. If there is DHCP
server in network, you can set the IP as "0.0.0.0", save and reboot DVR. In reboot
process, DVR will search the DHCP server and get one dynamic IP address. This item
will display the dynamic IP address. If DVR uses PPPoE function, also DVR can
dialup into internet and this item will display the dynamic internet IP address.
Port: Network access port number, must be greater than 2000.
Mask: This is sub net mask.
Gateway: The gateway IP is used to communicate in different network segments
Http Port: The port is for IE browser. The default value is 80. It can be modified.
Advanced settings: Move "Active frame" to "Advanced settings" then press
"enter" to enter the configure interface. Shown as Fig.5.29 below
Fig. 5.28 network setup
Unisight Digital Technologies, Inc
59
Advertisement
Table of Contents
