Unisight TZHEF04 Series User Manual page 11

Digital Video Network Surveillance System
Direction Keys
12
ENTER
13 PTZ
14 ESC
15 Reserved
16 F1
17 Lens control
18 F2
Placing the batteries into the IR remote control
1. Remove the battery cover.
2. Insert the battery. Please make sure that the poles (+ and －) are correctly placed.
3. Fold the battery cover.
Start to use IR remote control
Switch the device power on, wait without any operations until preview screen
appears, and then you can use IR remote control to manage DVR on condition that the
device ID is default "255", which can be changed in "Display" menu.
If the default device ID has been changed, please press [Power] & [DEV] key of
IR remote control, input the present device ID and then press [ENTER] key. Then you
can use IR remote control to operate this DVR.
Stop using IR remote control
When DVR controlled by IR remote control, press [DEV] key again, then the IR
remote control can not control this DVR.
Switch the DVR off
When IR remote control is working, press [POWER] key for several seconds,
then the power off prompt will pop up, press [Confirm] and switch off the power on
the rear panel manually.
When IR remote control can not work normally
Check batteries poles.
Check the remaining charge in the batteries.
Check IR remote control sensor is masked.
Same as direction keys and enter key
of front panel.
Same PTZ key of front panel.
Same as ESC key of front panel.
－
Key for Extension.
IRIS, FOCUS ZOOM for lens control.
Key for spot video output.
Unisight Digital Technologies, Inc
11