NCR 7454 User Manual page 137

6. Press at the screen prompt to enter the Setup Utility.
F2
7. In the
Advanced
8. Verify that the
LPT 1 Mode
9. Go back to the
Advanced
10. Set the
Parallel CD-ROM Boot
11. Exit Setup and Save Changes.
As the terminal reboots, you should see a message during boot
indicating that the CD-ROM has been recognized:
Micro Solutions BACKPACK CD-ROM v0.3
. . .
Booting from BACKPACK CD
Starting MS-DOS
12. Follow the screen prompts on the client to update the BIOS. You
can select two methods to run the update program.
Automatic BIOS Update – update process runs unattended
Note: You see a prompt for terminal model and serial number
information. If the program detects invalid information in the
current BIOS, or if you are replacing the Processor Board, there
is not model/serial number information in the BIOS.
Important: Model/Serial Number is mandatory for FitClient
operation.
Interactive BIOS Update – permits you to input/replace the
model/serial number information that is stored in the BIOS.
Note: Model/Serial number data that is currently stored in the
BIOS is displayed during power up.
13. When you get the green window, this indicates a successful update.
14. Remove the CD and then press any key to reboot.
13. When the system reboots, press
Setup.
14. In the menu, select
Exit
15. Exit Setup and Save Changes.
menu, select
I/O Device Configuration
is set to
ECP
menu, select
to
Enabled
at the screen prompt to enter
F2
Load Setup Defaults
Chapter 5: BIOS Updating Procedures
.
.
Multiple ROM Menu
.
.
5-3
.