Beyonwiz DP-Lite User Manual page 59

STB & PVR Function
5) Power Off during Recording
If you attempt to put the DP-Lite into standby mode while a recording is
in progress, a "Power Off" dialog will be displayed, as shown below.
You can then choose from the following options;
Later: the DP-Lite will return to standby mode when the current

recording(s) have completed.
Yes: the current recording(s) are stopped and the DP-Lite goes into

standby mode immediately.
No: the standby mode procedure is cancelled and the DP-Lite remains

on.
Use the LEFT/RIGHT buttons to select your desired option and press
OK.
52
If a timer starts while the DP-Lite is in standby mode, the DP-Lite will
turn on automatically and perform its operation until the timer has
completed. If remote control activity is detected during this period, the
DP-Lite will remain on so you can continue to use it without interruption,
otherwise it will return to standby mode.
NOTE
If AC power is not supplied to the DP-Lite properly (e.g. a power

blackout), it cannot perform a timer recording. If a timer fails due to
this reason, this timer remains in the timer list as notification.
If AC power is restored within a timer's duration, the timer will

become active immediately and recording will begin.
If AC power is not supplied for a long period i.e. several hours, the

internal clock of the DP-Lite will lose it's time setting, and all timers
will fail until the time setting is restored (see "Time Setting" section in
Chapter 4).
If you do not respond to the "Power Off" pop-up dialog, the DP-Lite

will behave as if you selected "Later", and return to standby mode
when the recording is finished