Beyonwiz DP-Lite User Manual page 37

Quick Setup
2) Manual Configuration
If you set "DHCP" to "Disable", you must input the network settings
manually. Use the NUMERIC and LEFT/RIGHT buttons to configure
the following items;
IP Address: enter a 12-digit IP address.

Subnet Mask: enter a 12-digit subnet mask.

Gateway: enter a 12-digit gateway.

Primary DNS Server IP: enter a 12-digit primary DNS server IP

address.
Secondary DNS Server IP: enter a 12-digit secondary DNS server IP

address.
30
Then press the RED button to update the LAN settings. A "LAN Status"
pop-up window will now appear to show you the updated LAN settings.
Press EXIT to close the "LAN Status" pop-up window
NOTE
If an address you need to input does not have 12 digits, use

preceding 0s to make it 12 digits in length e.g. an address of
"192.168.0.1" must be entered as "192.168.000.001".
The MAC Address setting will display the MAC address of the Ethernet

interface, but you cannot change it.
You can also press the GREEN button to open the "LAN Status" pop-

up window to check your settings.
If you change the DHCP setting to "Enable", the manual settings no

longer apply, however they will still display the previously set
configuration values.