If You Have Problems; Manual Code Search - Radio Shack 4-IN-1 REMOTE CONTROL Owner's Manual

15-1991.fm Page 11 Wednesday, October 20, 1999 10:37 AM

IF YOU HAVE PROBLEMS

MANUAL CODE SEARCH

If the 4-in-One Remote Control does not oper-
ate your remote-controlled devices when you
first set it up, you might have to manually find
the correct codes for your devices. You can try
all the codes listed in "Manufacturer Codes" on
Page 14 for your brand device, or you can fol-
low these steps to search the remote control's
entire library.
1. Manually turn on the device you want to
set up.
2. Press the corresponding device key (
, , or ).
VCR CBL AUX
3. Hold down until the red light blinks twice,
P
then press . The red light blinks twice
9 9 1
again.
4. Aim the remote control at the device you
want to operate.
5. Repeatedly press
key ( , , , or
TV VCR CBL
turns off.
6. When the device turns off, press
10 seconds to save the code. The red
light blinks twice.
Note: If you do not press
onds, the remote control does not save the
code.
• Because the 4-in-One's library has so
many codes, this can take several min-
utes.
• If your device turns off during the
search, but does not operate after you
lock in the code, begin the search
again, pausing longer between key
presses.
TV
then the device
POWER
) until the device
AUX
within
P
within 10 sec-
P
11
,