If You Have Problems; Manual Code Search - Radio Shack 6-in-1 Remote Control Owner's Manual

15-1923.fm Page 18 Monday, July 19, 1999 12:41 PM

IF YOU HAVE PROBLEMS

MANUAL CODE SEARCH

If the 6-in-1 Remote Control does not operate
your remote-controlled devices when you first set
it up, you might have to find the correct code for
your devices. You can try all the codes listed in
"Manufacturers' Codes" on Page 21 for the brand
of your device, or you can follow these steps to
search the 6-in-1's entire library.
1. Manually turn on the device you want to set
up.
2. Hold down
SET UP
light above turns on.
3. Press the corresponding device key on your
6-in-1 Remote Control (
on). Or, to search all the codes available to
or to control a device, press
AUX1 AUX2
or then the corresponding device
AUX1 AUX2
key. The red light blinks once.
4. Aim the 6-in-1 Remote Control at the device
you want to operate.
5. Repeatedly press
, or
PLAY POWER (All Lts On)
device responds to the command.
6. When the device responds to the command,
press within 5 seconds to save the
ENT
code.
Notes:
• If you accidentally overshoot the correct
code, repeatedly press
(CHANNEL + (On),
on the 6-in-1 to move back through
Lts On)
the codes until the device responds to the
command.
• If you do not press
the 6-in-1 does not save the code.
Need help? Call 1-800-989-4706
18
on the 6-in-1 until the red
, , , and so
TV VCR CBL
(
On CHANNEL + (On),
until the
then
LAST On
, or
PLAY POWER (All
within 5 seconds,
ENT