Replacing The Movable Upper Cutter; Storage - Husqvarna Viking Viking Huskylock s25 User Manual

REPLACING THE MOVABLE UPPER CUTTER

Turn off the main power switch and unplug the machine.
The movable upper cutter should be changed when it
becomes dull. The upper cutter can be replaced according
to the following directions. If you are having any dif culties,
consult your authorized HUSQVARNA VIKING® dealer.
• Open the front cover and set the movable upper cutter
(1) in S position (See page 11).
• Loosen the set screw (2) and remove the upper cutter (1).
• Turn the handwheel until the upper cutter holder is in its
lowest position.
• Place a new upper cutter in the groove of the upper
cutter holder and tighten the set screw (2).
• Make sure the front edge of the movable upper cutter is
0.5-1.0 mm lower than the cutting edge of the stationary
cutter (3).

STORAGE

When the machine is not in use, be sure to keep it unplugged.
Cover the machine with the dust cover to protect it from the
dust. Store the machine, so it is not
or humidity.
44
exposed to direct sunlight
1
2
3