Spool Stand; Telescopic Thread Stand; Attach The Waste Tray; Open Front Cover - Husqvarna Viking Viking Huskylock s25 User Manual

SPOOL STAND

Insert the spool stand then push to the right as illustrated.

TELESCOPIC THREAD STAND

Extend the telescopic thread stand to its full height, then turn
until it clicks into place.
Place the thread spools over the cone holders on the spool
pin.
If the machine is already threaded, straighten the threads to
prevent tangling.

ATTACH THE WASTE TRAY

Position the machine so the front is nearly aligned with the
edge of the table. Insert the U-shaped hooks of the waste
tray onto the two suction cups on the underside of the
machine. Make sure the trim falls into the bag while sewing.

OPEN FRONT COVER

First push the cover to the right as far as it will go (1) and
then pull it downward toward you (2).

CLOSE FRONT COVER

1
First pull the cover upward and then slide it to the left until it
locks.
2
Note: The front cover has a safety switch and the machine will not sew
if the front cover is open.
8