Cleaning After Sewing; Storage; Replacing The Lower Cutter; Lubrication - Husqvarna Viking Huskylock 905 User Manual

3-9. Cleaning after sewing

• First unplug the machine.
1. Open the front cover and free arm cover (See
page 3).
2. Remove all the lint with the brush from the
ac ces so ry box.

3-10. Storage

1. When the machine is not in use, disconnect it
from the power supply.
2. Cover the machine with the vinyl cover when
you have nished sewing.
3. Store the machine so that it is not directly
exposed to sunlight or humidity.

3-11. Replacing the lower cutter

Cutters are available as an accessory at your
authorized Husqvarna dealer.
• Unplug the machine
1. Open the front cover (See page 3).
2. Disengage upper cutter and turn to lowest
position.
3. Loosen the screw of the lower cutter and
remove the cutter.
4. Mount the new cutter.
5. Re-position the upper cutter.
6. Turn the handwheel so that the needles are
in their lowest position.
7. Make sure that the front edge of the cutter is
1~2 mm lower than the cutting edge of the
lower cutter.
8. Tighten the new cutter with the screw.
9. Always clean with the brush.

3-12. Lubrication

To make the machine run smoothly and quietly
some of the moving parts must be lubricated
once or twice a month when using the machine
normally and once a week when using it
fre quent ly. Always remember to unplug the
ma chine for service. Remove all excessive oil
before you start sewing.
1~2mm
Lowest position
–34–
—34—
Lower cutter
Upper cutter
Set screw