Needle Threader; Change Thread - Husqvarna Viking Viking Huskylock s25 User Manual

NEEDLE THREADER

To make threading the needles easier, use the needle threader
included with the accessories.
Turn the handwheel so the needles are in their highest
position and lower the presser foot. Make sure one of the
rectangular markings of the needle threader is pointing
upwards. Place the thread from right to left in the notch on
the tip of the needle threader.
Hold the needle threader against the needle. Move the needle
threader down to the needle eye and press gently against the
needle, causing a small metal pin to push the thread through
the needle eye and form a thread loop.
Use the needle threader to pull the thread loop out behind
the needle.

CHANGE THREAD

The following is an easy way to change threads:
1. Cut the thread in use near the spool, behind the guides
on the telescopic thread stand.
2. Remove the thread spool and place the new thread on
the spool pin.
3. Tie the end of the new thread to the end of the old
thread. Cut the thread tails to 2-3 cm (1") in length and
rmly pull both threads to test knot security.
4. Raise the presser foot to release the tension discs.
5. Pull the threads through the machine one at a time until
the knots are in front of the needle. If the threads do not
pull easily, check for tangles on thread guides or looping
under thread stand.
6. Cut the thread behind the knot and thread the needle.
When using standard thread spools, place the thread
Note:
unreeling disc as shown to prevent the thread from getting
caught on the edge of the spool.
3 – THREAD YOUR HUSKYLOCK™ 25 27
S