Thread Left/Chainstitch Needle (Yellow) - Husqvarna Viking Viking Huskylock s25 User Manual

THREAD LEFT/CHAINSTITCH NEEDLE
(YELLOW)
D on needle clamp)
(
• Raise the presser foot to release tension discs.
• Pass the thread from back to front through the thread
guide on the thread stand (1).
• Thread the top cover thread guide by pulling the thread
towards the left until it slips under the guide. Then pull
the thread along the right side of the button as illustrated
(2).
• While holding the thread with both hands, pass it
between the tension discs and pull it down to make
certain it is properly placed between the tension discs (3).
Continue to thread points (4-9).
• Slip the thread into the middle slot on the thread guide
(5) and into the slot on the take-up lever cover (6). Then
slip the thread into the middle slot on the thread guides
(7) and (8).
• Before threading the eye of the needle, make sure thread
is in front of thread guide located on the bottom of the
needle clamp (9).
• Thread the eye of the needle. Use the needle threader
(page 27) to make needle eye threading easier.
• Pull about 10 cm (4") of thread through needle eye to
hang free.
• Place the thread to the back, under the presser foot.
2
3
2
7
8
9
3 – THREAD YOUR HUSKYLOCK™
1
6
4
5
25
S
23