Thread Upper Looper (Green) - Husqvarna Viking Viking Huskylock s25 User Manual

THREAD UPPER LOOPER (GREEN)

• Raise the presser foot to release tension discs.
• Pass the thread from back to front through the thread guide
on the thread stand (1).
• Thread the top cover thread guide by pulling the thread
towards the left until it slips under the guide. Then pull the
thread along the right side of the button as illustrated (2).
• While holding the thread with both hands, pass it between
the tension discs and pull it down to make certain it is
properly placed between the tension discs (3).
• Thread the looper area of the machine following the green
color coded thread guides (4-9).
• Use the tweezers to thread the hole in the upper looper
from front to back (9).
• Pull about 10 cm (4") of thread through the looper and
place it to the back of the stitch plate.
18
2
2
5
9
8
6
7
1
3
4