Fanvil BW530 User Manual page 31

Enable Via rport
Enable PRACK
Long Contact
Enable URI Convert
Dial Without Register
Ban Anonymous Call
Enable DNS SRV
Forward Type
Forward Phone Number
Server Type
DTMF Mode
RFC Protocol Edition
Transport Protocol
RFC Privacy Edition
Subscribe Expire Time
Enable Conference number Set to use sever conference.
MWI Number
Click to Talk
Signal Encode
RTP Encode
Enable Session Timer
has no packets sending to device in private network to keep NAT
alive, user could set this function ON. It need set the keep alive
interval time less than the NAT server's.
Enable/Disable system to support RFC3581. Via rport is special
way to realize SIP NAT.
Enable or disable SIP PRACK function, suggest use the default
config.
Set more parameters in contact field; connection with SEM
server
Convert # to %23 when send the URI.
Set call out by proxy without registration;
Set to ban Anonymous Call;
Support DNS looking up with _sip.udp mode
Select call forward mode, the default is Off
Off：Close down calling forward
Busy： If the phone is busy, incoming calls will be forwarded
to the appointed phone.
No answer： If there is no answer, incoming calls will be
forwarded to the appointed phone.
Always：Incoming calls will be forwarded to the appoint
phone directly.
The phone will Prompt the incoming while doing forward.
Appoint your forward phone number.
Select the special type of server which is encrypted, or has some
unique requirements or call flows.
Select DTMF sending mode, there are three modes:
DTMF_RELAY
DTMF_RFC2833
DTMF_SIP_INFO
Different VoIP Service providers may provide different modes.
Select SIP protocol version to adapt for the SIP server which uses
the same version as you select. For example, if the server is
CISCO5300, you need to change to RFC2543, else phone may
not cancel call normally. System uses RFC3261 as default.
Set transport protocols, TCP or UDP;
Set Anonymous call out safely; Support RFC3323and RFC3325;
Overtime of resending subscribe packet. Suggest using the
default config.
Input the number of the server's voice-mail box
Set click to Talk (need practical software support).
Enable/Disable Signal Encrypt.
Enable/Disable RTP Encrypt.
Set Enable/Disable Session Timer, whether support RFC4028.It
- 31 -