Press
,
the current flow counter page.
After setting up output voltage/current and press
will start counting the timer till the breaker or fuse is open. The resolution of
the timer is 100us (0.1 ms) and the maximum counting period is one hour. If
counter doesn' t work after pressing
will display error message after two seconds. one of the following three cases
may happen:
A.
Connector not ready
If a fuse is not properly connected to the output connector or a breaker under
test has not been switched to ON position, the screen will glimmer to show an
error message as shown below.
B.
Current setting too large
The output current is set too big that a breaker is open or a fuse is burnt to open
before output current is reaching the setting value. The screen will glimmer to
, and then
,
= 1 .
= 1 .
:
F
L
!
!
:
in the main page to enter to
=
:
.
, error occurs herein and screen
:
.
44
.
F F
to output, system
!