After wiring is complete, select one DS3640/DS6024/DS8018/DS10014 as the
Master and the other three as the Slave A, B, and C. After the DS3640/DS6024/
DS8018/DS10014 is set to the Master, it will start searching for all Slaves that
are connected to the Master. Therefore, in order to reach the control status, user
must set up the Slaves before the Master is set.
To set a DS3640/DS6024/DS8018/DS10014 to the slave mode, press
, and
And then select the SERIES mode by turning the knob (SCPI command is
" PS:MODE SERIES" ) and then press
the next line for the MASTER/SLAVE selection. Turning the knob to select
SLAVE A (SCPI command is " PS:TYPE SLAVEA" ) for the DS3640/DS6024/
DS8018/DS10014 and press
procedure to set up SLAVE B and C for another two DS3640/DS6024/DS8018/
DS10014.
To set the master unit, press
enter the series/parallel setting option. And then use the knob to select the
in the main page to enter the series/parallel setting option.
L
L
to confirm. It will continue to
to confirm the setting. Using the same
=
=
L
, and
,
39
in the main page to
,