Motech DS3640 User Manual page 49

series mode (SCPI command is " PS:MODE SERIES" ) and press
confirm. It will continue to the next line for the MASTER/SLAVE selection.
Use knob again to select MASTER (SCPI command is " PS:TYPE MASTER" )
and then press
DS3640/DS6024/DS8018/DS10014 will start searching for all Slaves, as
graphically demonstrated below.
If wiring is correct, screen will appear:
After receiving the control order from the Master, all Slaves will be locked on
the SLAVE page that all keys except
be operated by press keys except controlled by the Master as graphically
demonstrated below.
Once the Master and Slave settings are done, users can then operate the Master
only to set up the output voltage and current.
To release from this operation mode (series operation mode in this example),
press (LCL) to access to the series/parallel setting page and turning the
knob to select OFF for series/parallel selection to leave the series or parallel
operation mode and back to the local operation mode that the
DS3640/DS6024/DS8018/DS10014 can be controlled by press the keys again.
It shall not change the operation mode while DS3640/DS6024/DS8018/DS10014
to confirm. After it is confirmed as the Master the
L
L
F
L
L
F L
:
=
=
L
. . .
=
=
:
are disabled so that slaves can not
:
40
to