Table of Contents
Advertisement
•
Install the adaptor to the back of the hood, using 6 screws.
Hood Installation
1.
Insert the power cable in the hood and tighten the wire clamp to screw in the cable.
2.
Align the hood's keyhole mounting slots over the 4 partially installed screws.
3.
Making sure the duct positions over the hood's duct adaptor, push the hood against the rear
wall.
Electrical Connection
1.
Using provided wire connectors, connect wires as follows:
BLACK to BLACK (A)
WHITE to WHITE (B)
GREEN to BARE or GREEN-YELLOW (C)
2.
Reinstall the wiring box converter. And plug back all the small connectors inside the hood.
3.
Reinstall the bottom plate, make sure that both grease guides are aligned with the holes
before installing grease pan.
4.
Using long nose pliers, pull out each of the grease guides, then set them in a way their ange
slightly protrudes above the bottom surface.
7
Advertisement
Table of Contents
