Hood Preparation - Kruger Alto S User Manual

Hood Preparation

1. Remove the bottom panel of the hood by removing its 7 mounting screws. Set aside the
bottom panel once it has been removed.
Vertical Exhaust Installation
1. Install the small shut-off plate, or backdraft damper, inside the back of the hood. Fig 1.1
2. Install the small shut-off plate, or backdraft damper, outside the back of the hood. Fig 1.2
Fig 1.1
3. Install the rubber gasket (Included) on the top of the hood, as shown below. Fig 1.3
Fig 1.3
5
2. Remove the wiring knock-out located
at the top of the unit.
3. Depending on the type of exhaust
options you would like to go with.
Please skip ahead to vertical exhaust
installation or horizontal exhaust
installation.
Fig 1.2