Table of Contents
Advertisement
Location Preparation
1.
Use the dimensional drawings above to lay out the range hood's mounting holes, wiring access
and ductwork. Mark the cabinet bottom and drywall where applicable.
2.
Make a cutout for the wiring and duct work.
3.
Install the ductwork so that it is ush with the range hood's mounting surface.
4.
Run two conductor wires from a power source to the hood location. Bring approximately 12''
of wiring through wiring hole.
5.
Drill 3/32" diameter pilot holes at th epoints where mounting holes are marked.
6.
Insert 4 mounting screws, leaving approximately ¼" of thread exposed.
4
Advertisement
Table of Contents
