Brinkmann ALL IN ONE Owners Manual Assembly And Operating Instructions page 4

STEP 1:
Remove nut from bottom of burner
assembly.
STEP 2:
Position the stand upside down as shown.
STEP 3:
Place burner assembly inside stand with
threaded bolt protruding through support
strap as shown.
STEP 4:
Thread nut onto bolt and securely tighten.
Do not overtighten.
STEP 5:
a. Set cooker with burner assembly upright
on flat surface. Make sure burner
assembly is securely attached to cooker.
b. Attach female SAE fitting on hose
assembly (using w" wrench) to the male
SAE fitting on the burner (using d"
wrench). Hold the male SAE fitting
securely with one wrench and turn the
female fitting with the other wrench until
they are tightly joined.
NOTE: Make sure the male SAE fitting on the
cooker is screwed into the air shutter and
tightened securely. Do not over-tighten as
the air shutter needs to move freely in
order to adjust air intake. Check the
attachment for proper connection every
time propane tank is connected to cooker.
Air Opening
STEP 6:
a. Align the holes in the leg brackets with the
screw holes in the base pan and attach
using 10-24 x s" screws and nuts.
Tighten securely.
b. Place the base pan with attached legs on
the cooker. Align the three legs of the
base pan with legs of the cooker. Press
down firmly until there is no gap between
bottom of base pan and top of cooker.
3
Turn w" Wrench
Air Shutter Valve
Nut
Support Strap
Burner Assembly
Stand
Hold d" Wrench