Material Bay Leds; Replacing Material Spools; Storing Material Spools - Stratasys uPrint User Manual

Material bay LEDs

The table below will show the status indicated by the LEDs.
On
Off
Blinking

Replacing material spools

Removing a spool of material from the carrier:
1. Place the carrier on a flat stable surface.
2. Unlatch the carrier and open.
Remove the spool of material. Discard any pieces of material that may remain in
3.
the carrier.
4. Remove the material guide and recycle. See
on page 60
5. Recycle the empty material spool. See
6. Install a new material spool into the material carrier.

Storing material spools

If you will not be using the printer for more than 72 hours, unload and store model and support
material in the storage bags provided to prevent moisture absorption.
1. Unload material from the printer.
2. Open the material bay doors by gently pressing in to release and pulling outwards.
3. Remove the material carriers by first pushing them in to unlatch and then pulling them
outwards.
4. Place the carrier on a flat stable surface.
CAUTION:
carrier, doing so can cause material to break or become tangled.
Open the carrier.
5.
6. Rotate the spool to rewind the material, leaving 2 inches (50mm) remaining at the material
guide. See
30
Material currently loaded to the head
No carrier present
Carrier present and ready to be loaded
Carrier needs replacement (is empty or has an error)
Do not push the material through the material guide back into the
Figure 22.
"Removing the EEproms from the material guides"
"Recycling Codes" on page 59