Table of Contents
Advertisement
INSTALLATION
Mounting the Variable Speed Wall Control
17
Plaster Board
To mount the wall control on a plaster board
wall, use the controller cradle as a template,
and drill a 20mm hole (Fig 18-1) for the low
voltage cable and 2 10mm holes (Fig 18-2)for
the mounting hooks. Insert mounting hooks
into the holes(Fig 19).
19
Align and screw the cradle into position.
When selecting a position for the wall
control, avoid the following locations:
Direct sunlight
An outside wall
Any heat sources
(eg. refrigerator, heater etc.)
A position in direct line of a cooling outlet
Mounting the wall control in a position
near any heat source or cooling outlet will
affect its ability to control temperature.
It is advisable to locate the wall control
about 1.5 metres above the floor level in
the room that is used or most lived in.
18
20
Cradle
2
1
Cradle
15
Hide quick links:
Advertisement
Table of Contents
