Timed Automatic Stop; Using The Cooler; Air Too Cold; Air Not Cold Enough - Braemar Down Series Owners Manual Installation, Operating & Service Instructions

WALL CONTROL FUNCTIONS

Timed Automatic Stop

You can also set the cooler to turn off after
a set number of hours.
1. To set a delayed stop time, press TIMER
with the cooler running. "Stopping in" will
display.
2. Press or
hours before the cooler will stop. The
maximum delay setting is 24 hours.
3. Press TIMER again to begin timed stop.

Using The Cooler

Now that you have read these instructions, press the POWER button to turn your
cooler on. If the cooler has not operated for a while "Pre Cool Cycle" will flash on
the display. The "Pre Cool Cycle" will begin and will take only a few moments to
complete. After this time, the fan will come on automatically, and you can enjoy
the comfort of cool fresh air.

Air Too Cold

With the cooler running in automatic mode, you may find that you are too cold or
that the cooler is blowing too much air. Press
temperature setting and reduce the amount of cooling.
If you are to cold with the cooler running in Manual mode, then press
the fan sped. You can also circulate uncooled fresh air by pressing COOL until
"Vent" displays.

Air Not Cold Enough

You may find that with the cooler running in Automatic mode, that you are not cool
enough. Simply press
If you are not cool enough with the cooler running in Manual mode, then press
to increase the fan speed. Ensure that cooled air is circulating by pressing COOL
until "Cool" is displayed.
to adjust the number of
to increase the cooling rate.
30
to lower the automatic
19
ILL1137-A
to reduce